|
It's not the least expensive, but I've always had good experiences with Makita products in the past, so the choice was easy.I've been boring holes in treated lumber, studs, joists, glue lam beams, ect. I've been using this drill for a few weeks and my only regret is that I waited so long to buy one. This was purchased to replace another angle drill I had been using (yellow and black) that didn't perform to my expectations, when it finally died I went with the Makita. with a self feeding bits, and this drill powers through with no problems. Only downfall is the Allen key holder that is built into the grab handle, the wrench tends to fall out sometimes, this didn't keep me from giving it 5 stars, I just leave the key in the case.
amazon was great,great price and quick shipping.the drill is wonderful.having owned and used the hole hawg in the past,this ones better.im a plumbtrician so i need to drill holes from a half inch to five and a half inch diameter on a daily basis.i use my inch and an eight 18" naileater and even in southern yellow pine it hardly bogs the drill down.use sharp bits and be sure to read the directions for bracing the drill.it will hurt you quickly.
based on price.performance.features.this tool is a best buy in the category of commercial quality plumbing-electrical specialty drills
The time had come to bite the bullet and invest in a substantial heavy-duty drill. These were done one after another, on a hot day, with no sign at all of fade from the drill. The DA4031 has also drilled all the holes for my railing support posts. I then used a ½" x 12" self-feed auger bit to drill sixteen holes through 9" of lumber for the lag bolts on the cantilever support. Best of all, the switch handle rotates a full 90 degrees in either direction at the press of a button. I chose the Makita over the DeWalt Timberwolf and Milwaukee HoleHawg because of the added power (10 amps) and features.
The Makita's spade handle adjusts 90 degrees to any position with an Allen wrench that is stored cleverly in the handle. The auxiliary rubber-grip pipe handle screws into either side. I'd made due with my 3/8" drill in the past and borrowed whenever I needed larger, but I knew that wouldn't cut it for this summer's project. I couldn't be more pleased with the quality of construction, ergonomics, or power. I pre-drilled each hole to depth with the DA4031, then (using a ½" drive socket adapter) turned each lag screw in flush (final tighten by hand). The final tighten required a ½" x 18" breaker bar, so I know turning the lags in was no cakewalk. I will probably never come close to using this drill to its full potential, but I like having a quality tool with more than enough power to get any job done.
That's good, because at 12 pounds, this is a serious piece of equipment.Now back to the project. I'm happy to report that the project is nearly complete and the DA4031 has delivered in spades. Final verdict. These combined features make the drill comfortable to hold in any position. In building my deck, I affixed the ledger board to the house with twelve ½" x 10" galvanized lag screws (3.5" of ledger board, 2.5" of wallboard, 10" of sill beam). Nothing on this project came close to stressing this drill. The DA4031 has both these bases well covered.
|
